Submission Details

29 Mar 2014
enthusiast League

Rankings and Points

World Record Rank
Not Mat_Agnesi's Best 3DMark Vantage - Performance Submission
NVIDIA  GeForce 8800 GT 512 Mb  Rank
32.2 Points
Global 1 Cores GPU Team Power Rank

Images

Hardware Details

Processor

Model Intel Core i7 2600K Sandy Bridge Cooling Air (Custom) Cores 5,000 MHz (+47.06%)

Memory

n/a

Videocard

Model NVIDIA GeForce 8800 GT 512 Mb (G92) Cooling Air (Custom) Speed 600 MHz / 750 MHz (Stock) buy on amazon

Motherboard

Model GIGABYTE G1.Sniper M3 Cooling Air (Stock) Chipset Z77

Disk

n/a

Power Supply

n/a

Comments

March 29, 2014 at 7:13:39 PM UTC

FRANKESTEIN CARD, this is an 8800GT with the 8800GTS's Power supply.

Made by me from two broken CARD, the 8800GT has broken VRM, and the 8800 GTS has broken CORE.

 

Both Core and RAM is powered by the external 8800GTS's power supply.

 

Very Crappy Qimonda RAM can't Overclock more than 1060MHz even downvolted...

March 29, 2014 at 11:55:32 PM UTC

lol...awesome mod bro and nice result...;)

March 30, 2014 at 8:33:07 AM UTC

asus 8800GT top don´t need another vrm , because it have one enought powerfull for G92 chip .

 

it have L6713A pwm ..just moded fb pin and ocp mod .

the "secret" is to put a jummper or dip switch on the FB wire ...boot in windows with jummper removed ( without FB mod- on), and then in OS put the jummper back ..then you will be able to inceerese voltages ...without OVP trigger... :D

 

for the mem , you need REVERSE vmod , because qimonda ic´s are very difficult to bench with lot of voltages , need degreese the voltage ..just moded the FB pin to + vram vrm output , and you will be able to reverse voltages .. measure before the ressistance between the fb pin and out+, and then put a trimmer x 20 over that value

good look!

March 30, 2014 at 11:03:36 AM UTC

Lol !

March 30, 2014 at 1:38:25 PM UTC

Those 3 phase need good cooling and can sustain 1.5v+ an air/water, no nned for zombie (if the card VRM is OK, of course).

 

Even two phase VRM with very good cooling can sustain a G92 GPU with big air voltages:

 

Check below:

 

http://hwbot.org/submission/2345165_poparamiro_3dmark_vantage___performance_geforce_8800_gt_256_mb_8975_marks

 

If you have e golden board with defective VRM, is wothed to zombified.

March 30, 2014 at 1:43:27 PM UTC

lol!

March 30, 2014 at 7:37:31 PM UTC

Thanks everyone for the interest. My custom power supply cutted from the 8800 GTS is modded and has a wide range voltage regulation. GPU voltage can be set from 1,1v to 1,8v. RAM voltage can be regulated from 1,5v to 2,3v.

For that crappy Qimonda RAM I've used 1,9 volt, and for the Core 1,45v

 

In fact, nachtfalke & poparamiro is right, not so much difference in overclock between the original Asus's power supply and my 8800 GTS's power supply. RAM stop at the same frequency, The core can go only a little higher than before and need a lot of voltages to raise more.

 

what voltage do you usually give to that G92 chip ??

 

For sure, this is not a Golden Card...it's crappy, right ?

 

but I have liked that experiments, it's funny.

March 31, 2014 at 5:36:57 PM UTC

The PCB has a total of 4 phase, 3 for GPU and 1 for RAM. This came from a 8800GTS, I think 8800GTX has more powerful power section.

however, this one that I have has supplied also my AMD HD 6850 (little overclocked) without problem ! not bad for that old mosfets

Log in or register to comment