Inane work on this board ! 267mhz mem with tight subs are pretty much lead You to max out every chip You just want ! Very nice, very nice ! I'm curious of Your future work, keep pushing ! ;)

Awesome work. Voltmod of MCP Is need?

Nice. You made a mediocre board a superstar. It's awesome.

well done!

Nice work Good Show

Over the years I have had 2 of these boards and never tried them the lack of 12v CPU power put me off will have to try one oneday.

Wow, that's awesome!

Thanks all. I will recheck some of cpus with NF7v2 in next few weeks (NF7 is also strong on fsb and validates 275MHz) to see if Asus board is not limiting me on total cpu clock and will later share my trick to break 260 Mhz with A7N8X.

9 hours ago, GRIFF said:

Voltmod of MCP Is need?

The resistor I use gives the lowest of 2.05v (that is combo of 2 resistors actually) - going to 2.15v worsens stabilty.  I think voltmod is necessary but 2.05v may be unnecessary.

What helps me for stability is modded 3.3V PSU rail and HAL set to "Standard PC". Of course modded bios is a must. Most of my boards don't scale much above 2-2.1V vdd and very often higher voltage hinders the stability. I even have one NF7 that can't do 250+ stable if the vdd is higher than 1.8V.

Interested to see if you know something else

PS: Try a locked XP 2500+ if you have one. It's cool to beat unlocked CPUs, just because you run much higher FSB

Edit: Ah, you have one.

1 hour ago, I.nfraR.ed said:

Ah, you have one.

I broke the core of the best one this summer, other 2500+ won't go high enough.

1 hour ago, I.nfraR.ed said:

Interested to see if you know something else

Actually I can share it here - bus 0 dev 0 func 3 offsets 66 and 68 - set both to C7 or 07 (haven't yet bothered to identify the exact bit - although should be simple - just one of those 2 bits in 11xx0111 sequence with xxxx0xxx being mandatory). Don't know what it is exactly - was bruteforcing it in wpcredit - with zero impact on performance.

Thanks. Have you checked if those are set differently on other boards?

I'm still trying to finish the ZenStates release and then will probably play with K7 and K8 a little.

I have DFI Ultra-B, NF7, AN7 - could check on all of them, but it requires some free time.

respect bro

Very nice score, well done! Especially on this board... I'm curious what your "trick" to reach 260Mhz+ on the A7N8X is... ;)

Very nice score. My board back then didn’t even come close...