Search Results
Official HWBOT Partner

Submission Details

1372 markswith Core i7 4770K@5655.64 MHz

Hardware Details

Processor

Model Intel Core i7 4770K Haswell-DT Cooling Liquid Nitrogen Cores 5,655.64 MHz  (61%) REF 101.00 MHz

Memory

Type DDR3 SDRAM

Motherboard

Model Z87 OC Formula Chipset Z87

Comments

leeghoofd commented on own score:
 – Retesting 5ghz 1.385 Vcore CPU, no go over 6ghz 1core, 4/8 seems acceptable, CB at -115°C Not tweaked for performance (as usual)
September 17, 2013 at 12:17:13 PM GMT

it was a 5ghz 4c8t 1.385v?

September 17, 2013 at 12:21:48 PM GMT

yep, boots at 1.385 into win7 4/8 and runs 1M, AIDA CPU Queen, PhotoworXX on air.

 

Same CPU runs 4600 1.23Vcore AIDA stress test stable.

 

Re-testing the other one tonite... wished it could do 6100 1 core and 5800 all cores, but nope...

 

None optimised runs with the Corsair 2800C11 CFR kit... +1400 should be doable at them CPU speeds...

September 17, 2013 at 12:31:43 PM GMT

Which batch is this one?

September 17, 2013 at 12:32:18 PM GMT

so voltage on air is not always an important sign , my 6280mhz 01 chip was 4c8t 1.385 only for xp... but not bad with ln2... and i had an 6200 chip for 3Ds and 6050 for 06 that could not boot even 4.8 below 1.4v on air. and some 5ghz 1.41v that can not pass 06 @ 5700

September 17, 2013 at 12:38:22 PM GMT

I think you still need low voltage on air but it has to scale on cold and high voltage.

My first 4670K did 1,15V 4500 MHz primestable which was a very good one. 6,3 GHz max valid and 6,1 for 32m.

 

I had a 4770K which did 4500 MHz at 1,175 Volt which is just a little bit worse but it did not scale on cold at all. 5,9 GHz max on LN2...

 

But the L313B996 ones which only did 4300 MHz at 1,275 V primestable were 5,5 to 5,6 max valid on LN2.

September 17, 2013 at 12:39:10 PM GMT

Batch is L316B432 sr nr: 35310047A1952

 

This chip needs high uncore/NB, eg setting it at 50X would shutdown the setup at +5800Mhz, with 52X it was far more stable...

 

looking for better :P

September 17, 2013 at 12:45:41 PM GMT

you looking for some chips like this? ...

http://www.8pic.ir/images/81643667854035628361.jpg

 

1.088 for cinebench :D

September 17, 2013 at 12:47:39 PM GMT

just want a bulletrpoof retail +6Ghz bencher for 3D 4/4... my quest continues...

September 17, 2013 at 12:50:41 PM GMT

you looking for some chips like this? ...

http://www.8pic.ir/images/81643667854035628361.jpg

 

1.088 for cinebench :D

 

And then you end up with a CB at -90°C and a max clock of 5,8 haha

September 17, 2013 at 12:55:52 PM GMT

nope only only only on this one i was not so bad luck :D cb is -116 and 3Ds 6350-6400 and 6540 pifast, i buy cpus from one same batch to make sure about not a very bad cb :D

September 17, 2013 at 1:05:47 PM GMT

scatter benching as usual :D

September 17, 2013 at 1:07:26 PM GMT

What did you expect dino :P

September 17, 2013 at 3:24:58 PM GMT

interesting cache behaviour there albrecht, i have found my chip shut down earlier than normal sessions, so ill try mess with cache a little :)

September 17, 2013 at 5:41:49 PM GMT

5.65GHz/1200MHz and 1370m of score, is no good efficiency;)

September 17, 2013 at 6:06:09 PM GMT

No tweaks applied to the rams as mentioned in the comment :P this is done on a daily OS too... just testing a CPU...

Log in or register to comment