Rankings and Points
Global Team Power Rank
0.0 Points
DDR5 SDRAM
Team Power Rank
Comments
FLL not set?
Lock up/shutdown or BSOD? Have you tried VCCIN 2.3-2.7 if the former, or easy memory settings like 7200 if the latter?
@george FLL was set to ratio OC, @seby Lockups only, no BSOD or shutdown, VCCIN only tried between 1.8 and 2.1v (seemed like it was getting worse with more, though might have been condensation at that point
Can also try really low SA like 1.1, or Doomed says his chips need high SA like 1.35+, but it really should be pretty easy, especially if other board did it fine
SA didnt seem to really help if i added over 1.4v from 1.25 being sweetspot for cascade(-100c), will try dropping below 1.2v and see if that gains me anything. Oh low mem clocks including JEDEC havent influenced the CB.
only thing that seemed to drop the CB a little was IVR TX, that got me from -165 to around -180c but very unreliable
@ShaggySVK maybe just need @Hiwa to use that plastic straw and "brush" some more vaseline in the socket, what could go wrong?
In all honesty did you get the board all cleaned up?
Dude, I spent half a day rewashing that board and its still somehow a regenerating new layer of vas on surface everytime you heat it up :D
socket and mem slots are all mint, washed those out multiple times with contact cleaner, no residues there.
find harder to full pot with encore than white maybe due to new bios try to go back to previous bios or use mode 2 with ln2 mode enable and load preset too, keep in mind that ivr increase around 0.1v compare to ambiant and sa same
Log in or register to comment