Insane result! Good work Petri.

What would intel's engineers say about that voltage?

congrats petri, that's a sick result.

Are you sure it's not mem limited? (with 7-7-6 most hypers stop scaling around 1080-1100 and at 1120 they're already barely benchable, no matter the volts)

great job! what about the other voltages pll,vccio,vccsa etc...thanks

great job! what about the other voltages pll,vccio,vccsa etc...thanks

Sam- It is the cpu clocks which is limiting. I was already doing some higher freq runs, but with lower CPU speed. The score was worse + other issues. So I think with some new CPU I will try to show 1140Mhz+ runs for you

Zoro- 1.9 VDDR, 1.25 VCCSA, 1.1 VCCIO, 1.8VCPUPLL, Skew + driving voltage changes. Subtimings tweaked a tiny bit.

It could be bios limited! are you sure about vccsa and vccio? i would expect them to be reverced! is the cpu alive?

Zoro- Yes, I am pretty sure that my eyes does not lie and my fingers set the correct values CPU is still in perfectly good condition.

Very nice result ... again! 30 GB/s finally done!

That is already a good cpu, I can tell you. Tested 5 until now and only one chip could do 108 BClock, but only with low cpu frequency. Higher frequencies on cpu and ram should need more VCCIO ... as much as the chip can take. Same as it was with Lynnfield.

Your voltages are really strange. Couldn't touch VCCSA on the UD7, because the whole system got unstable. VCCIO is very low for your memory frequency and timings.

Thanks _mat_!

I think MIVE is very good board and very easy to use. I don't know why UD7 behaves that way

1.9v vddr 2250+ 7-7-6 is awesome!

You must mean "only" 1.9V

wow i missed this one

well done dude this is a crazy OC. love it

where's ya superpi 32M mate